Tideflex Series 2633

Open Access / Tideflex Duckbill Valves

Tideflex S2633 check valve data sheet

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

Post comment with email address (confirmation of email is required in order to publish comment on website) or please login to post comment

1. Materials of Construction  Steel, stainless steel or PVC body.  Steel, stainless steel or PVC end connections.  Check sleeves available in pure gum rubber , neoprene, Hypalon ® , buna-N, Viton ® and EPDM.  Eliminates check valve chatter.  Can be mounted in any position.  Is ideal for pneumatic systems.  Closes on entrapped solids. A L H Valve Size Length Body O.D. Weight Steel Max. Back- A L H (lbs.) pressure (psi)* 1/2 4 1/2 2 3/4 3 75 3/4 4 1/4 2 3/4 3 75 1 4 1/2 2 3/4 3 75 1 1/2 6 1/2 3 3/4 8 50 2 7 1/2 4 14 25 3 8 1/2 5 18 25 Dimensions Series 2633 Small Diameter InLine Check Valve Series 2633 Numbers indicate maximum dimensions in inches. * Saddle Support T echnology not available for 2633. Manufactured on the same principle as Tideflex ® Technologies’ revolutionary all- rubber Tideflex ® InLine Check Valve, the Series 2633 is a simple inline check valve for threaded end pipelines. Simple in design, the Series 2633 consists of a body, two endcaps and an elastomer check sleeve. In the open posi- tion, the sleeve creates a wide, free passage proportional to the flow in the pipeline. On flow reversal, the sleeve closes slowly and completely. The silent, non-slamming Series 2633 InLine Check Valve design eliminates water hammer and facilitates low headloss. Containing no levers, balls, floats or springs to corrode, the valve is virtually mainte- nance-free. The only replacement part is the simple, rugged elastomer check sleeve. This small and simple inline check valve is ideal for liquids, gases, powders, slurries and instrument or plant air as well as in any environment where preventing back- flow is required. The Series 2633 is manufactured in sizes 1/2" to 3". The check sleeve is available in a variety of elastomers to match specific service conditions.

Views

  • 17 Total Views
  • 12 Website Views
  • 5 Embeded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+