Design Form - Aeration System

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

Post comment with email address (confirmation of email is required in order to publish comment on website) or please login to post comment

1. Aeration System Design Data Form Tideflex Technologies 6 00 N. Bell Ave . Carnegie , PA 15 1 0 6 412 - 279 - 0044 Fax: 412 - 279 - 5410 Email: info@tideflex.com (Click on Gray Box & input value; Units Box will expand for US or SI designation) GENERAL INFORMATION Project Identification Name : Facility Name: Location: Address: Facility Supervisor: Phone: Fax: Email: Consulting Engineering Firm: Location: Address: Engineer Contact: Phone: Fax: Email: DIFFUSED AERATION REQUIREMENT Oxygen Transfer & Adequate Mixing Mixing Only Su pplemental Oxygen Only TYPE OF AERATION SYSTEM REQUESTED Fine Bubble Coarse Bubble Combination Fine & Coarse Evaluate All 3 Options GENERAL COMMENTS

3. Aeration System Design Data Form Tideflex Technologies 6 00 N. Bell Ave . Carnegie , PA 15 1 0 6 412 - 279 - 0044 Fax: 412 - 279 - 5410 Email: info@tideflex.com WASTEWATER CHARACTERIZATION Plant Loadings (For Aeration Tank Design) [Total for All Tanks] Average Design Influent Peak Design Influent Required Effluent FLOW MGD BOD5 mg/l COD mg/l NH3 mg/l Operating MLSS Concentration mg/l Wastewater Operating Temperature Degrees F Average Food to Biomass Ratio Peak Food to Biomass Ratio Actual Oxygen Required AOR lbs/day Air Flowrate Available cfm Waste Sludge Loadings (For Aerobic Digester Design) [Total for All Tanks] Waste Sludge Flowrate MGD Solids Concentration in Influent mg/l Percent Volatiles in Influent % Percent Volatiles to be Reduced % Sludge Concentration within Tank mg/l Actual Oxygen Required AOR lbs/day Air Flowrate Available cfm Wastewater Holding (For Sludge Holding, Septage Holding & Equalization) [Total for All Tanks] Solids Concentration within Tank mg/l Actual Oxygen Required AOR lbs/day Air Flowrate Available cfm Desired Unit Mix Rate to be appled cfm / 1000 cuft liquid Additional Design Parameters [Total for All Tanks] Description Value Units

2. Aeration System Design Data Form Tideflex Technologies 6 00 N. Bell Ave . Carnegie , PA 15 1 0 6 412 - 279 - 0044 Fax: 412 - 279 - 5410 Email: info@tideflex.com TA NK / BASIN GEOMETRY Total Number of Tanks: Parallel Operation Series Operation Tank Bottom Material: Concrete Steel Plastic/Fiberglass Clay Bottom Elevation [MSL] Ft Rectangular Tank or Channel (Straight Sidewall) Length Ft Width Ft Side Wall Height Ft Additional V-Bottom Depth (at centerline of V) Ft Bottom Slope (if sloped to end of tank) [%] Operating Water Depth Ft Circular (Flat Bottom) Diameter Ft Side Wall Height Ft Bottom Slope to Center [%] Operating Water Depth Ft Circular (Conical Bottom) Diameter Ft Side Wall Height Ft Cone Depth at Center Ft Operating Water Depth (top of cone to water level) Ft Horizontal Circular Diameter Ft Horizontal Length Ft Flat Ends Domed Ends Open Top Manway Access Diameter Ft Manway Location (from end of tank) Ft Operating Water Depth (measured at centerline to water level) Ft Rectangular Lagoon Top Length Ft Top Width Ft Water Surface Length Ft Water Surface Width Ft Bottom Length Ft Bottom Width Ft Sidewall Slope [%] Operating Water Depth Ft Special Construction (Insert all relative information)

4. Aeration System Design Data Form Tideflex Technologies 6 00 N. Bell Ave . Carnegie , PA 15 1 0 6 412 - 279 - 0044 Fax: 412 - 279 - 5410 Email: info@tideflex.com Re -Aeration Systems [Total for All Tanks] Flowrate MDG Influent Dissolved Oxygen Conc. mg/l Required Effluent Dissolved Oxygen Conc. mg/l Actual Oxygen Required AOR lbs/day Oxygen Uptake Rate mg/l/hr Chloride Conc. (solubility limit) mg/l AERATION SYSTEM PIPING MATERIALS Drop Pipe Sch. 10 – 304L SS Submerged Manifold Piping Sch. 40 PVC Drop Pipe Sch. 10 – 304L SS Submerged Manifold Piping Sch. 80 PVC Drop Pipe Sch. 10 – 304L SS Submerged Manifold Piping Sch. 10 – 304L SS Drop Pipe Sch. 10 – 304L SS Submerged Manifold Piping Sch. 5 – 304L SS Drop Pipe Sch. 10 – 3 16 L SS Submerged Manifold Piping Sch. 10 – 3 16 L SS Drop Pipe Sch. 10 – 3 16 L SS Submerged Manifold Piping Sch. 5 – 3 16 L SS Drop Pipe Sch. 10 – 304L SS Submerged Manifold Piping Sch. 40 HDPE DIFFUSER RETROFIT INFORMATION Brand Name of Existing Diffusers / Description: Fine Bubble Coarse Bubble Total Number of Diffusers per Tank: Threaded Connection Diameter: in Normal Operating Airflow per Tank: cfm Maximum Operating Airflow per Tank: cfm

Views

  • 20 Total Views
  • 13 Website Views
  • 7 Embeded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 1

  • 1 www.measurit.com