DISCOVER OUR IMPRESSIVE PERFORMANCE ADVANTAGE

For more information please visit www.measurIT.com

If high flowmeter accuracy is demanded, even with inadequate straight pipe, a flow conditioner should be used. There are many types of flow conditioners available (vanes, tube bundles, perforated plates); however the VORTAB flow conditioner offers several advantages. The VORTAB's unique tab design (see sketch above) provides excellent isolation from disturbances, little pressure loss, and immunity to fouling.

Use a flow conditioner.
Flowmeter manufacturers usually provide 'recommended installation' instructions with their products. These instructions specify the minimum amount of straight, unobstructed pipe that should be located upstream and downstream of the flowmeter. It's often not possible to provide this required straight pipe due to space constraints and economic demands. Consequently, flowmeter accuracy suffers as a direct result of an inadequate amount of straight pipe.

Flowmeter - easy to install, easy to use.
The ST50 Flowmeter is an accurate, easy to install, no moving parts solution for measuring and controlling air, compressed air or nitrogen flow.

ST50 utilizes FCI proven thermal dispersion technology to provide direct mass flow measurement resulting in higher performance at a lower cost than orifice plates, DP, Vortex shedding and other thermal device.

Should you require higher levels of accuracy, wider ranges of gases to be measured or seek for High Performance flowmeters - please click here.

Mass gas flowmetering is easy using FCI Insertion Flowmeters. Get wide turndown of 100:1 or even 1000:1, enabling simple detection of leaks and peaks. Mass flow accuracy of 1% instills confidence and drives cost saving decisions. No moving parts means no maintenance. Simple set up speeds installation in various pipe sizes.